Teac AI-503 Mode D'emploi page 20

Playing back music on a computer (continued)
Playing back audio files from a computer
1
Connect this unit to the computer using a USB cable.
USB cable
o Use a commercially-available USB2 . 0 cable (A-B type) for this
connection .
2
Turn the computer on.
o Confirm that the operating system has started properly .
3
Shift the POWER switch to its ON position to turn
the unit on.
4
Turn the INPUT SELECTOR knob to select USB.
20
5
Start playback of an audio file on the computer.
Better sound quality can be achieved by maximizing the com-
puter output volume and adjusting the volume output of this
unit .
Minimize this unit's volume before starting playback . Then,
gradually turn it up .
When using headphones connected to this unit, turn the
VOLUME knob counterclockwise to minimize the volume
before putting them on . Then, gradually increase it .
o The computer and this unit cannot control each other .
o Do not do any of the following when playing back an audio file
via USB . Doing so could cause the computer to malfunction .
Always quit the audio playback software before doing any of the
following .
i Unplugging the USB cable
i Turning this unit off
i Changing the current input selection
o When playing back an audio file via USB, computer operation
sounds will also be output . If you do not want these sounds to
be output, make appropriate settings on the computer to turn
them off .
o If you connect this unit with the computer or change its input to
USB after starting the audio playback software, audio files might
not play back correctly . If this should occur, restart the audio
playback software or restart the computer .