Main Components; Assembly Components; Rod Installation; Handle Assembly - GGP ITALY TR 24 Li Manuel D'utilisation

IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.

3.4 MAIN COMPONENTS

The machine is composed of a series
of main components that have the
following functions (Fig.1 ):
A. Power unit: it drives the cutting means
through a transmission shaft.
B. Rod: it connects the rear hand
grip to the power unit.
C. Cutting means: the element
designed to cut the vegetation
1. Cutting line head: nylon
line cutting means.
D. Cutting means guard: it is a safety
device which prevents objects drawn
up by the cutting means from being
hurled away from the machine.
E. Front hand grip: semi-circular shaped,
it is used to handle the machine.
F. Rear hand grip: used to handle the
machine and equipped with the main
on/off/acceleration control buttons.
G. Battery (if it is not supplied with the machine,
see chapter 15 "accessories on request"):
device that supplies electric current to the
tool; its specifications and regulations for
use are described in a specific manual.
H. Battery charger (if it is not supplied
with the machine, see chapter 15
"accessories on request"): device
used to recharge the battery.
4. ASSEMBLY
IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these indications to avoid
serious risks or dangers.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the
assembly should be done on a flat and
stable surface, with enough space for
machine handling and its packaging,
always making use of suitable equipment.
Do not use the machine until all the
indications provided in the "ASSEMBLY"
section have been carried out.

4.1 ASSEMBLY COMPONENTS

The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
Before assembling, make sure the
battery is not inserted in its housing.

4.2 ROD INSTALLATION

1.a Model TR 24 Li B
– Insert and push the lower part of the
rod (Fig. 3.A) in the upper part (Fig.
3.B) until your hear the stop pin that
blocks it in the right position.
NOTE The rod cannot be
removed once it is assembled.
The rod length is adjustable (par. 6.1.3).
1.b Model TR 24 Li
– Align the upper part of the rod (Fig.
4.A) with the lower part (Fig. 4.B),
following the direction of the arrows;
– push the lower part in the rod upper part;
– once inserted, tighten the knob securely
(Fig. 4.C) following the direction of
the arrow - closed padlock.
– Make sure the lower and
of the rod are carefully tightened.

4.3 HANDLE ASSEMBLY

4.3.1 Assembly of the front hand grip
1.a Model
– Insert the front hand grip (Fig. 5.A) on
the shaft (Fig. 5.B), with the seat of
the screw oriented on the left side.
EN - 8
upper part
TR 24 Li B