GGP ITALY TR 24 Li Manuel D'utilisation page 34

14. TROUBLESHOOTING
PROBLEM
1. The cutting means
is stationary and the
machine does not start
when the throttle control
lever and throttle safety
lever are engaged
2. Motor overheating
3. Grass accumulates
around the power
unit housing and the
cutting line head
4. The line is not released
when the automatic
release is turned on
5. The cutting means
comes into contact
with a foreign body.
6. Excessive noise and/or
vibration is experienced
whilst working
7. The machine gives off
smoke whilst working
8. Battery power
reserve is low
If problems persist after having performed the above operations, contact your dealer.
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
The separable rod was not fully or
properly inserted in its housing
Defective throttle control lever/
throttle safety lever
Machine damaged.
Grass caught under the
cutting means guard
Too high grass is being cut
close to the ground
The line is stuck to itself
Not enough line on the
reel or reel empty
The line is worn and too short
The line is tangled on the reel or broken Remove the line from the reel
-
Loose or damaged parts.
Machine damaged.
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Decrease in battery capacity
Make sure that the battery is
inserted correctly (par. 7.2.3)
Check the battery status and
recharge if necessary (par. 7.2.2)
Make sure the separable rod was
and correctly inserted (par. 4.2)
Do not use the machine. Immediately
turn off the machine remove the battery
and contact a service centre.
Do not use the machine. Immediately
turn off the machine remove the battery
and contact a service centre.
Remove caught grass (par. 6.5)
Cut tall grass with a top down
movement to avoid accumulations.
Lubricate with silicone spray
Replace the reel (chap. 8.1.1)
or the line (chap. 8.1.2)
Release the line manually (chap. 6.4.2.)
and rewind it (chapter 8.1.2)
Turn off the machine, remove the battery and:
- inspect for damage;
- check for and tighten any loose parts;
- have all replacements or repairs carried
out by an authorised service centre.
Turn off the machine, remove the battery and:
- inspect for damage;
- check for and tighten any loose parts;
- have all replacements or repairs carried
out by an authorised service centre.
Do not use the machine. Immediately
turn off the machine remove the battery
and contact a service centre.
Optimise operations
(par. 7.2.1)
Use a second battery or
battery (par. 15.1)
Purchase a new battery
EN - 16
SOLUTION
installed
extended