GGP ITALY TR 24 Li Manuel D'utilisation page 22

• Beware of injuries
caused by devices used
to cut the line length.
If something breaks or an
accident occurs during work,
turn off the motor immediately
and move the machine away to
prevent further damage; if an
accident occurs with injuries
or third parties are injured,
carry out the first aid measures
most suitable for the situation
immediately and contact the
medical authorities for any
necessary health care. Carefully
remove any debris which could
cause damage or injury to
persons or animals if ignored.
Prolonged exposure to
vibrations can cause injuries and
neurovascular disorders (also
called "Raynaud's syndrome"
or "white finger"), especially to
people suffering from circulation
disorders. The symptoms can
regard the hands, wrists and
fingers and are shown through
loss of sensitivity, torpor,
itching, pain and discolouring
of or structural changes to
the skin. These effects can
be worsened by low ambient
temperatures and/or by gripping
the hand grips excessively
tightly. If the symptoms occur,
the length of time the machine
is used must be reduced
and a doctor consulted.
Use limitations
• Do not use the machine if
you are unable to hold it with
both hands or keep it steady
on your legs while working.
• Never assemble metal cutting
means. The use of metal or
rigid blades of any type with
this machine is prohibited.
• Never use the machine
with damaged, missing or
incorrectly positioned
• Don't use the machine if
the attachments/tools are
not installed in their seats.
• Never disengage, deactivate,
remove or tamper with
the safety systems/micro
switches installed.
• Do not use the power tool
if the switch does not turn it
on and off. Any power tool
that cannot be controlled
with the switch is dangerous
and must be repaired.
• Do not strain the machine
too much and do not use a
small machine for heavy-
duty work. If you use the right
machine, you will reduce the
risk of hazards and improve
the quality of your work.
2.4 MAINTENANCE,
STORAGE
Ensure regular maintenance
and correct storage to
maintain machine safety and
high performance levels.
Maintenance
• Never use the machine
with worn or damaged parts.
Faulty or worn-out parts
must always be replaced
and never repaired.
• Be careful during adjustment
of the machine
entrapment of the fingers
between moving parts of
the cutting means and fixed
parts of the machine.
The noise and vibration
levels shown in these
EN - 4
guards.
to prevent