Preparing And Maintaining The Wireless Temperature Sensor - Bosch HEZ39050 Notice D'utilisation

en
g
Wireless temperature
sensor
Additional information can be found in
u r e s e n s o r W i r e l e s s t e m p e r a t
the detailed instruction manual for the
hob in chapter "Cooking Assist
Functions". Read it through carefully.
Preparing and maintaining the
wireless temperature sensor
In this section, you will find the following
s e n s o r e l e s s t e m p e r a t u r e n t a i n i n g t h e w i r P r e p a r i n g a n d m a i
information:
Adhering the silicone patch
■
Using the wireless temperature
■
sensor
Changing the battery
■
You can obtain a temperature sensor
and silicone patches from specialist
retailers or through our technical
after-sales service. Always quote the
relevant reference number.
00577921 Set of 5 silicone patches
HEZ39050 Temperature sensor and set of
5 silicone patches
Adhering the silicone patch
The silicone patch attaches the
temperature sensor to the cookware.
A silicone patch must be adhered when
using a saucepan with the cooking
functions for the first time.
Proceed as follows:
The adhesion point on the saucepan
1.
must be free of grease. Clean the
saucepan, dry it thoroughly and wipe
the adhesion point with a degreasing
agent such as spirit.
10
Remove the protective film from the
2.
silicone patch. Adhere the silicone
patch to the saucepan in the correct
place using the the enclosed
template as a guide.
Press the silicone patch down,
3.
including its inside surface.
The adhesive requires 1 hour to fully
harden. The cookware must not be
used or cleaned during this time.
Notes
Cookware with the silicone patch
■
must not be left to soak for long
periods in soapy water.
If the silicone patch comes off,
■
attach a new one.
Using the wireless temperature sensor
Attach the temperature sensor to the
silicone patch and align it correctly.
Notes
Make sure that the silicone path is
■
completely dry before attaching the
temperature sensor.
Position the cookware in such a way
■
that the temperature sensor is
pointing towards the outer side of
the hob.