Maintenance And Cleaning; Simplified Eu Declaration Of Conformity - Indexa DVT30 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

the wall (see Fig. D).
#
Locate the antenna in a better position by using an antenna extension
cable (extends the supplied antenna cable) – see chapter 19 optional
accessories.
16. Changing the batteries in the outdoor
station
If the indoor sation does not react to pressing the door bell button [47] or if
there is only one bar in the battery status indicator [13], then the batteries must
be changed.
In this case:
!
If necessary loosen the bracket [80] of the antenna cable [72], so that
there is some slack in the cable.
!
Unscrew the two security screws [71]in the holes [67] with the supplied
screwdriver [36] and remove them.
!
Carefully lever the outdoor station [41] out of the mounting bracket [63]
and if necessary unscrew the antenna cable from the anntena connection
[48].
!
Unscrew the seven screws [53] without removing them from the cover
[49].
!
Lever the cover from the outdoor station.
!
Remove the expired batteries and place 6 new alkaline AA 1.5 V batteries
in the battery compartment [55] observing the correct polarity
!
Refit the cover and tighten the seven screws.
!
If necessary screw the antenna cable on to the antenna connection.
!
Refit the outdoor station into the mounting bracket as follows:
!
If fixed, push the antenna through the underside of the antenna hole.
!
Push the outdoor station up into the mounting bracket until it touches
the top side.
!
Now pull the top end of the outdoor station outwards until the lower
end can be pushed into the mounting bracket.
!
Press the lower end of the outdoor station into the mounting bracket
and insert the two security screws as far as possible into the two holes,
then tighten these using the screwdriver.
!
If necessary rescure the antenna bracket such that the antenna points
upwards (see Fig. D) .
17. Reset
In case of a software crash, when there is no reaction to the pressing of any
button, reset the system as follows:
!
Hold the reset button [29] pressed, using for example the end of a paper
clip, until the picture on the screen disappears.
!
Hold the on/off button [24] on the indoor station pressed until the power
LED lights red.
Note:
The settings will remain saved.
52 - GB

18. Maintenance and cleaning

#
The products are maintenance-free: Never open this, except when
changing batteries.
#
Check the safety and function regularly
#
Remove the mains adapters from the mains sockets before cleaning
#
Use a soft, slightly moist cloth or brush to clean the surfaces
Do not use cleaning agents containing solvents, Petrol, alcohol or similar. These
can be damage the surfaces. Also the fumes cause a danger to health and of
explosion. Do not use any sharp tools (eg screwdrivers) or metal brushes for
cleaning.
19. Optional Accessories
#
Additional camera DF270K with accessoires. Art. Nr. 27276
#
Antenna extension cable for camera with wallbracket (to extend the cable
distance between antenna cable and antenna)
RG142SMA-2M, length 2 m, absorption 1,6 dB, Art. Nr. 27243
RG142SMA-4M, length 4 m, absorption 3,2 dB, Art. Nr. 27244
ANT07-10M, 7 dB
Antenna with 10m connection cable, absorption
Art. Nr. 27247
20. Disposal
Do not dispose of packaging material, used batteries or products as
household waste. Please use your recycling system. Details are available
from your local authority.
21. Simplified EU declaration of
conformity
Hereby, INDEXA GmbH declares that the radio equipment type DVT30 is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
http://www.indexa.de/w2/f_CE.htm.
22. Warranty
In addition to the statutory guarantee from the vendor, the manufacturer
warrants this product for 2 years from date of purchase (proof from receipt)
according to following conditions.This warranty does not affect your legal
rights.
The warranty covers use of the product in normal conditions in private
households. It only covers manufacturing defects and is limited to the
replacement or repair of the faulty components. It does not include wear and
tear, or batteries.
The warranty applies only when the product is used according to the operating
instructions. It does not cover damage arising from misuse, improper handling,
application of force, dust, dirt, water or other environmental factors, or from
incorrect voltage from batteries or power supply.
The warranty is void when the product has been repaired or tampered by
unauthorised persons and when it has been used with components which are
not specified by the manufacturer.
,
5dB,

Publicité

Table des Matières
loading

Table des Matières