Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
terminals [27].
Note:
The outdoor station must not be
operated with batteries AND the power supply
unit at the same time!
!
If you are using an optional door release with its own power
supply, connect it with two wires to terminals [27] NO/COM
(max. 1 A at up to 15 V AC/DC). Please also follow the
information provided in the door release operating instructions.
!
If you are using an optional external signal generator with its
own power supply, connect it with the two wires for the signal
generator connection [32] (normally open contact, max. 1 A at
up to 15 V DC).
!
If you are using an optional button to open the door, connect it
with two wires to the terminals [27] "Button for DR" and GND.
!
If you are not using the connection cables [32] for the external
signal generator, cut them off immediately next to the connection
terminals.
!
Screw the connection cover [41] in place on the outdoor station
with the four screws supplied [38] so that any cables come out at
the bottom of the outdoor station over the angled surface.
!
Push the outdoor station into the mounting bracket [33] and
tighten it using the torx screwdriver [43] and the torx screw [42].
Note
that if batteries are to be used, any cables should have enough
slack that the outdoor station can be removed in order to change
the batteries.
!
If operating with the power supply unit, connect it to 230 V AC.
!
When a connection is made to the power supply, the light on the
ring button [25] turns green.
!
Remove the two pieces of protective film from the camera lens [23]
and loudspeaker area [18].
10. Maintenance and cleaning
#
The products are maintenance-free: Never open this, except when
changing batteries.
#
Check the safety and function regularly
#
Remove the mains adapters from the mains sockets.
#
Use a soft, slightly moist cloth or brush to clean the surfaces
Do not use cleaning agents containing solvents, Petrol, alcohol or
similar. These can be damage the surfaces. Also the fumes cause a
danger to health and of explosion. Do not use any sharp tools (eg
screwdrivers) or metal brushes for cleaning.
11. Disposal
Do not dispose of packaging material, used batteries or
products as household waste. Please use your recycling
system. Details are available from your local authority.
12. Simplified EU declaration
of conformity
Hereby, INDEXA GmbH declares that the radio equipment type DVT40T
is in compliance with Directive 2014/53/EU. The full text of the EU
16
declaration of conformity is available at the following internet address:
http://www.indexa.de/w2/f_CE.htm.
13. Legal Notices
This product or software may contain or make use of code under the GNU
General Public License v2 e.g. the linux kernel, the GNU Lesser General
Public License v2.1 or the Apache licence v2.0.
For further information regarding license terms and – where required by
license – source codes please send an email to
copyrequest@indexa.de to get them free of charge. Some licenses,
however, require the provision of physical copies of the source code. In
this case, you may obtain a copy of the source codes by contacting us as
well via copyrequest@indexa.de. A nominal fee (i.e., the cost of
physically performing the source distribution) will be charged for this
service.
Note:
your copy of this product may not contain code covered by one or
more of the licenses listed here, depending on the exact product and
version you choose.
The corresponding license texts can be found at the end of the manual.
v1.0
14. Trouble shooting
Refer to chapter "Trouble shooting" in
basic set.
.
the operating instructions of the
Indexa GmbH
Paul-Böhringer-Str. 3
74229 Oedheim
Germany
www.indexa.de
Subject to change
2018/03/20
Publicité
Table des Matières
