Starting The Pump - Alaris IVAC P6000 Mk II Mode D'emploi

Getting Started

Starting the Pump

1. Connect the pump to an AC power supply
using the AC power cable. Press the
ON/OFF button.
2. NEW PATIENT? - Answering NO will retain
all the previous history. Answering YES will
automatically reset the patient history to
zero. Check the time and date displayed is
correct.
The question
AUTOSAVE is disabled; all patient history
will be reset.
3. LOAD SYRINGE - Load the syringe
according to
Procedure in the Getting Started section of
this user manual.
4. CONFIRM SYRINGE - Check that the
syringe type and size being used matches
the display. If required, the type of syringe
can be changed by pressing the TYPE
button. Press CONFIRM when the correct
type and size are shown.
5. Check the rate shown if old patient data
has been retained and change the rate if
necessary using the ADJUST buttons.
6. PURGE (if required)
PURGE/BOLUS button then the two
PURGE softkeys together until fluid flows
and the purging of the syringe extension
line is complete. The audible alarm will
operate during use of the PURGE buttons
and the volume used during purging will be
shown on the display.
7. CONNECT PATIENT
extension line to the patient access device.
8. START - Press START to commence
operation. INFUSING will be displayed.The
AMBER STOP light will be replaced by the
flashing GREEN START light to indicate
that the pump is operating.
The unit will automatically operate from its internal battery if the pump is switched on
without being connected to the AC power supply.
Each time the unit is switched ON, check that the alarm beeps twice and that all the
segments of the display, the green and amber lights are illuminated during the self test
routine.
During PURGE/BOLUS: pressure limit alarms are temporarily increased to their
maximum level, no alarms are disabled during a Bolus infusion or the use of the Purge
button.
8 / 99
is bypassed if
the LOAD SYRINGE
- Press
- Connect
the
the
the
Important:
6001FAOPT71 ISS 8