TFK buggster S air Notice D'utilisation page 9

OPERATING AND ASSEMBLY MANUAL
Fitting the wheels
-(Fig. I) Insert the rear wheels (1), holding down the red sliding button
(2) as you do so. When the wheel is inserted as far as it will go, release
the button (2) and check its fit. To release, hold down the red button
(2) and pull the wheel off.
-(Fig. II) Insert the front wheel (3) into the support, until you hear it
click into place. To release, press the red button (4) and pull the
wheel off. The front wheel can be either fixed (Pos. 1) or swivelling
(Pos. 2). Rotate the knob (4) until the numbers are aligned with the
arrow.
Getting ready for use
-(Fig. III) Pull the two handles (5) upwards until you hear the joints (6)
click into place.
(Fig. IV) Pull the rear frame apart slightly on the left and right and
then press the rear joint (7) downwards, until the safety lock engages.
-(Fig. V) Push the bumper bar (8) up. To do this, press the two red
buttons on the left and right and move the bumper bar (8) upwards.
-(Fig. VI) Activate the parking brake by pushing the rocker lever (9)
down. To release, pull the lever (9) up.
-Please always lock the rear wheels when placing your child in the
buggy and strapping it in.
-(Fig. VII) Open the buckle (10) of the 5-point harness by pressing the
button in the centre and pulling out the tongues (11) of the shoulder
straps. Now sit your child in the buggy and position the shoulder
straps correctly. Place the two tongues (11) on top of each other
and insert them into the buckle (10) between the child's legs, until
you hear the buckle engage. You can alter the length of the strap to
suit the size of your child using the fasteners (12).
9