Abicor Binzel ABITIG MT 260W Mode D'emploi page 29

®
ABITIG MT
®
6.1.2 ABITIG MT 260W/400W/500W
1
1 Gas nozzle
2 Gas diffuser
Fig. 2
1 Screw the tungsten electrode (3) into the gas diffuser (2) from behind.
2 Insert the gas diffuser (2) into the torch body (4) from the front.
3 Hold tungsten electrode (3) and gas diffuser (2) and screw on guide tube (5) but do not
tighten.
4 Set tungsten electrode (3) to the desired stick-out and tighten the guide tube (5).
5 Screw in gas nozzle (1).
6.2 Shortening the tungsten electrode
The electrode type is set by EN ISO 6848. The max. length of electrode depends on the type
of torch.
 3.1 Technical Data on page EN-5
NOTICE
• The welding performance is affected by the selection of the tungsten electrode and by
wear. A smooth, groove-free sharpened end of the tungsten electrode has a positive effect
on the welding result.
6.3 Connecting the cable assembly
1 Plug the hose assembly connection into the power supply and secure it with a connection nut.
2 Properly mount the connections for water supply/return, shielding gas and control line plug.
BAL.0107 • 2020-04-15
2 3 4
3
4
Equipping the ABITIG
5
Tungsten electrode
Torch body
®
MT 260W/400W/500W
6 Putting into operation
5 Guide tube
EN - 11