Abicor Binzel ABITIG MT 260W Mode D'emploi page 28

6 Putting into operation
6.1 Equipping the TIG welding torches
CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the wire electrode.
• Keep your hands out of the danger zone.
• Wear the correct protective gloves.
®
6.1.1 ABITIG MT 200/300W
1
8
1 Setting gauge
2 Electrode holder
3 Adapter
Fig. 1
1 Insert the electrode holder (2) into the adapter (3) from the front.
2 Slide tungsten electrode (4) from the front through the adapter (3) into the guide tube (5).
3 Screw electrode holder (2) containing the tungsten electrode (4) into the guide tube (5) but
do not tighten.
4 Set the length x using the setting gauge (1).
The length x depends on the welding task.
5 Tighten electrode holder (2).
6 Screw pre-mounted unit (6) into the torch body (7) as far as it will go.
7 Screw in gas nozzle (8).
EN - 10
4
2 3
x
7
4 Tungsten electrode
5 Guide tube
6 Pre-mounted unit
Equipping the ABITIG
5
6
®
MT 200/300W
ABITIG
7 Torch body
8 Gas nozzle
BAL.0107 • 2020-04-15
®
MT