Setting The Clock Time; Setting The Clock Manually - PERFECTPRO LUNCHBOX2 Mode D'emploi

Setting the clock time

Setting the clock automatically-Radio Data System (RDS)
When you set the clock time using the RDS function, your radio will synchronize its clock time
whenever it tunes to a radio station using RDS with CT signals.
1. When tuning to a station transmitting RDS data, press and hold the Menu button to enter the
setting menu.
2. Rotate the Tuning control until "RDS CT" shows on the display. Press the Tuning control to enter
the setting.
3. Rotate the Tuning control until "CT ON" shows on the display. Press the Tuning control to confirm
the selection. The clock time of the radio will be set up automatically according to the RDS data
received.
4. If you want to disable the clock time (CT) automatic adjustment function. Rotate the Tuning control
to select "CT OFF" and press the Tuning control to disable the function. Now the clock time can be
set manually, please follow the steps described in the section of "Setting the clock manually."

Setting the clock manually

1. Clock can be set either the radio is power on or off.
2. Display will show "-:--" when the batteries are installed or when the radio is connected to the mains
supply.
3. Press and hold the Menu button to enter the setting menu. Rotate the Tuning control until "TIME
SET" shows on the display. Press the Tuning control to enter the setting.
4. Rotate the Tuning control to set the desired hour. Then press the Tuning control to confirm the
setting. The minute digit will flash on the display.
5. Rotate the Tuning control to set the desired minute. Then press the Tuning control to confirm the
setting. Press the menu button to exit.
12/24 hour clock format
1. Press and hold the Menu button to enter the setting menu. Rotate the Tuning control until 'CLOCK
24H (or 12H)' shows on the display. Press the Tuning control to enter the setting.
2. Rotate the Tuning control to choose between 12 or 24 hour clock format. Press the Tuning control
to confirm the setting.
Operating your radio - FM/AM auto - tune
1. Straighten up the antenna.
2. Press the Power button to switch on your radio.
3. Press the Source button until the FM/AM band is selected.
4. Rotate the Tuning control in a clockwise direction. The displayed frequency will increase. Then
press the Tuning control to carry out an auto-tune. Your radio will scan up the FM/AM band
from the currently displayed frequency and will stop scanning when it finds a station of sufficient
strength.
To scan down in frequency, rotate the Tuning control in an anticlockwise direction first and then
press the Tuning control. Your radio will scan down the FM/AM band from the currently displayed
frequency and will stop scanning when it finds a signal of sufficient strength.
5