Factory Reset; Software Version; Backlight Timeout - PERFECTPRO LUNCHBOX2 Mode D'emploi

Factory reset

If you wish to completely reset your radio to its initial state this may be performed by following this
procedure. By performing a factory reset, all user entered settings will be erased.
1. Press and hold the Menu button to enter the setting.
2. Rotate the Tuning control until 'FACTORY' shows on the display. Press the Tuning control to enter
the setting menu.
3. Rotate the Tuning control until "RESET" shows on the display. Press the Tuning control to enter
the setting menu.
4. Rotate the Tuning control to select 'YES' and press the Tuning control to confirm the setting. A full
reset will be performed. Presets will be erased. All the setting will be set to their default values.
If you do not wish to carry out a system reset, select 'No' and then press the Tuning control. The
display will revert back to the previous display.
In case of malfunction due to electrostatic discharge, reset the product using the above procedure.
In some circumstances it may be necessary to disconnect and then reconnect the mains power in
order to resume normal operation.

Software version

The software display cannot be altered and is just for your reference.
1. Press and hold the Menu button to enter the setting
2. Rotate the Tuning control until "FACTORY" shows on the display. Press the Tuning control to enter
the setting menu.
3. Rotate the Tuning control until 'P X' (e.g.P01) appears. Current software version is shown on the
display.
4. Press and release the Menu button to exit the software version display.

Backlight timeout

Your radio allows you to adjust the length of time that the backlight stays on when you are not
operating your device.
This feature can be adjusted when the radio is on or off.
1. Press and hold the Menu button to enter the setting
2. Rotate the Tuning control until "LIGHT" shows on the display. Press the Tuning control to enter the
setting.
3. Rotate the Tuning control to select your desired backlight timeout option (10 seconds/20 seconds/
30 seconds/remain backlight ON), then press the Tuning control to confirm the setting.
Note: If you select backlight ON, the display backlight will remain illuminated when the radio is turned
on, but when the radio is switched off, the backlight will dim after 30 seconds.
9