PERFECTPRO LUNCHBOX2 Mode D'emploi page 7

5. After a few seconds the display will update. The display will show the frequency of the signal
found.
6. To find other stations press the Tuning control as before. When the end of the waveband is
reached, your radio will recommence tuning from the opposite end of the waveband.
7. Adjust the Volume to the required setting.
8. To switch off your radio, press the Power button.
Note:
If you find the reception is poor, try repositioning the antenna.
Manual Tuning - FM/AM
1. Press the Power button to turn on the radio.
2. Select the required waveband by pressing the Source button.
3. Be sure to screw in the rubber FM antenna properly to get best reception. For AM (MW) band,
rotate the radio to get best signal.
4. Rotate the Tuning Control knob will change the frequency in the following increments
FM: 50 or 100 kHz
AM (MW): 9 or 10 kHz (10 kHz setting for AM band in North America)
5. Rotate the Volume Control knob to get required sound level.
6. To turn off the radio, press the Power button. Display will show OFF.
Memory presets stations - FM/AM
Storing stations in preset memories, please follow below step.
There are 5 memory presets for each waveband.
1. Press the Power button to turn on the radio.
2. Tune to required station by pressing the Source button and the Tuning control.
3. Press and hold down the required preset until the preset number stops flashing until the radio
beeps. The preset number will appear in the display and the station will be stored under chosen
preset button.
4. Repeat this procedure for the remaining presets.
5. Stations stored in preset memories can be over written by following above procedures.
Recall stations from preset memories - FM/AM
1. Press the Power button to turn on the radio.
2. Select the required waveband.
3. Momentarily press the required Preset button, the preset number and station frequency will appear
in the display.
GB
6