König Electronic CMP-NWIPCAM11 Mode D'emploi page 8

[Restore Default]: Used to restore all parameters of the IP Camera (including network
parameters, excluding physical address) to their default settings.
Note: Please use this function carefully!
[Reboot]: Used to reboot the IP Camera. The IP Camera will reboot in about five
seconds.
Setting Video Parameters of IP Camera
The interface for setting the Video parameters of the IP Camera is as follows:
[Image size]: Used to set the resolution of images. You may select a resolution of
VGA (640*480) and QVGA (320*240).
Note: It will take about 15 seconds to change the resolution.
[Quality]: Used to select image quality. The default is set to fine.
Note: To achieve an ideal effect on the network, it is necessary to set the above two
parameters the transfer speed and amount of traffic of the network.
[Environment Power Frequency]: Used to select the power frequency of the
[Audio]: Used to turn on/off the audio function of the IP Camera. In some occasions, it
is not necessary to activate the audio function. Please disable the audio input
to save DSP resources and network resources.
Note: Audio is disabled by default.
[Mirror]: Image mirror button.
[Flip]: Image flip button.
[Video mask set]: Set the image mask area.
operating environment. Incorrect settings may
cause the image to blink.
8