König Electronic CMP-NWIPCAM11 Mode D'emploi page 13

If the IP Camera is set for dial-up Internet access within a router or other IP sharer, it is
required to setup an ADSL dial-up account and password on the IP Camera (for details,
refer to Setting ADSL Account and Password), and it is referable to set the DDNS
domain service at the same time (for details, refer to Setting DDNS). Click <Apply>
and the IP Camera will reboot. After rebooting, reconnect the IP Camera according to
the network structure shown in the above figure. Wait for several minutes and the IP
Camera will dial up to access the Internet automatically, and the communication with
the DDNS server has been established successfully. In this way, the user can access
the IP Camera from a WLAN by using the DDNS domain name.
(2) Connecting directly with an ADSL Modem for Internet access Set an ADSL dial-up
account and password (for details, refer to Setting ADSL Account and Password),
and it is preferable to set the DDNS domain name at the same time. Click <Apply>
and the IP Camera will reboot.
After rebooting, disconnect the power supply and network cable of the IP Camera
and then reconnect them according to the network structure shown in the above
figure. Wait for several minutes until the IP Camera will dial up to access the Internet
automatically, and the communication with the DDNS server has been established
successfully at the same time. In this way, the user can access the IP Camera via the
Internet by using the DDNS domain name.
3. Accessing the IP Camera from the Internet
For each ADSL reconnection, ISP will re-assign a new IP address for the IP Camera
to facilitate the access. The user can also enable DDNS service at the same time.
Upon completion of the settings, we can access the IP Camera through a registered
fixed domain name address.
Setting wireless functions of IP Camera
The IP Camera supports wireless networking functionality. Wi-Fi parameters like the
IP address, subnet mask, gateway, SSID, and so on can be set on the camera.
For the settings on your router or access point, please refer to the manual of that.
After setting the parameters for the router or access point, enter the wireless function
setting interface of the IP camera.
13