König Electronic CMP-NWIPCAM11 Mode D'emploi page 10

Note: If [Alarm record in PC] is not selected, motion alarm will also be recorded to
the SD card automatically.
Setting Advanced Parameters of IP Camera
The interface for setting the Advanced parameters of the IP Camera is as follows:
E-mail function triggered by IP Camera alarm
Settings related to the sending of e-mails depend on whether the motion detection
alarm settings are enabled. If an alarm is triggered, the system will send an alarm
message to a designated e-mail box.
Operation procedures:
Step 1: [SMTP server]: Fill in the name and address of the mail server of the sender,
for example, SMTP.goscam.com.
Step 2: [MAIL from]: Fill in the e-mail address of the sender;
Step 3: [MAIL to]: Fill in the e-mail address of the recipient;
Step 4: [SMTP username]: Fill in the user name used to log on to the e-mail box of
the sender;
Step 5: [SMTP password]: Fill in the password used to log on to the e-mail box of the
sender;
Step 6: [MAIL title]: Fill in the title of the e-mail message to be sent;
Step 7: [Alarm send mail]: Select the check box to enable the function;
Step 8: Click <Save> to complete the setting.
Note: To activate the settings upon completion, it is necessary to reboot the IP Camera
and the alarm.
UPNP settings of IP Camera
The UPNP can automatically map the data port and Web port to the router according
to the settings. An extranet user can access the Intranet via the mapped ports.
Step 1: [Enable UPNP]: Click to turn on the UPNP setting switch;
Step 2: [UPNP network card]: Select the type of network card from the drop-down
menu;
Step 3: [UPNP mode]: Select mapped port and mode in the drop-down menu
10