König Electronic CMP-NWIPCAM11 Mode D'emploi page 14

Select the Enable Wi-Fi check box.
[Gateway]: Enter the IP address of the wireless router, for example, 192.168.1.254.
[Subnet mask]: Enter subnet mask, for example, 255.255.255.0.
[IP Address]: Enter the IP address to access, for example, 192.168.1.2 (the IP address
must be in the same network section as the gateway address, for
example, it cannot be set to 192.168.2.2).
[SSID]: Enter the wireless network name set in the wireless router, for example,
111111.
The setting of the wireless function of the IP Camera is now completed. Disconnect
the network cable of the IP Camera and access the camera through the wireless
IP address
Setting User Management Parameters of IP Camera
The interface for setting the User Management parameters of the IP Camera is as
follows:
Each IP Camera can be configured for two different kinds of users: one is an
administrator, and the other is a common user.
Note: The administrator can set the parameters of the IP Camera, while the common
user does not have the right to edit such settings.
Default username of administrator: admin Password: admin
Default username of common user 1: user1 Password: 1
14