Maintenance And Cleaning; Important - EINHELL ROYAL ELS 2000E Mode D'emploi

Anleitung ELS 2000 02.03.2004
GB
7.3.2 Blowing (Fig. 7)
Turn the lever (8) all the way right to "Blower".
◆
You can do this regardless of whether the tool is
running or not.
Channel the air stream forward and walk slowly
◆
to blow foliage or garden refuse into a pile or to
clear out hard-to-reach places.

Important!

Empty the debris bag before blowing. Otherwise, the
material that has been vacuumed up could drop out.
7.3.3 Emptying the debris bag and pre-screen
(Fig. 1)
Empty the debris bag (7) in good time. When the bag
is heavily loaded with material, vacuum power is
considerably reduced. Deposit organic refuse at a
compost site.
Switch off the tool and pull out the plug.
◆
◆ Open the zipper on the debris bag (7) and
shake out the material.

8.0 Maintenance and cleaning

IMPORTANT!
All maintenance, service and cleaning work must
be performed after the power cord has been
pulled out.
◆ Do not use high-pressure cleaners or running
water to clean the tool.
Do not use any aggressive cleaning agents.
◆
◆ After shaking out the debris bag, turn it inside
out and thoroughly clean it in order to prevent
mould and unpleasant odors from forming.
You can use soap and water to clean out a
◆
heavily soiled debris bag.
Rub a bar of dry soap across the zipper teeth if
◆
the zipper becomes difficult to pull.
Always keep the tool and ventilation slats clean.
◆
Use a damp rag to wipe dirt marks off of the
◆
tool. Clean the vacuum/blower tube with a brush
upon evidence of dirt and grime.
Dirt and grime can make the switch
◆
(blower/vacuum) more difficult to operate as a
result of the material that swirls up off the
ground. When this occurs, simply flip the switch
back and forth a few times, which should bring it
back to the normal feel.
9.0 Repair
Should the tool experience problems beyond those
12
10:39 Uhr Seite 12
mentioned above, let only an authorized professional
or a customer service shop perform an inspection.
10.0 Disposal
The tool, accessories and packaging should be
disposed of in an environmentally-friendly fashion.
Plastic parts are coded for purposes of separation
when recycling.
11. Ordering replacement parts (fig. 1)
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
Pos. RP.-Nr.
1+2 34.330.60.01
3 34.330.60.03
4 34.330.60.04
5 34.330.60.05
7 34.330.60.07
9 34.330.60.09