Cleaning, Maintenance And Ordering Spare Parts; Disposal And Recycling - EINHELL GE-CL 36 Li E Mode D'emploi

6.7 Battery capacity indicator (Fig. 3 / item 2)
Press the battery capacity indicator switch (a).
The battery capacity indicator (2) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The battery pack has been deep-discharged and
is defective. Do not re-use or charge a defective
battery pack.
7. Cleaning, maintenance and
ordering spare parts
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
•
After shaking out the catch bag, turn it inside
out and thoroughly clean it in order to prevent
mould and unpleasant odours from forming.
•
You can use soap and water to clean out a
heavily soiled catch bag.
•
Rub a bar of dry soap across the zipper teeth
if the zipper becomes difficult to pull.
•
Clean the vacuum/blower tube with a brush
upon evidence of dirt and grime.
•
Dirt and grime can make the switch (blower/
vacuum) more difficult to operate as a result
Anl_GE_CL_36_Li_E_SPK7_USA.indb 12 Anl_GE_CL_36_Li_E_SPK7_USA.indb 12
EN
of the material that swirls up off the ground.
When this occurs, simply flip the switch back
and forth a few times, which should bring it
back to the normal feel.
7.2 Maintenance
•
Should the tool experience problems
beyond those mentioned above, let only an
authorized professional or a customer service
shop perform an inspection.
•
There are no other parts inside the equipment
which require maintenance.
7.3 Ordering replacement parts:
Service
1. If your power tool requires service,
contact an authorized Einhell USA dealer
or call the Einhell USA customer service
center at 1-866-EINHELL
(1-866-346-4355). Only identical
replacement parts should be utilized for
repairs. This will ensure that the safety of the
power tool is maintained.
2. If the battery charger cable is damaged, it
must be immediately replaced to avoid a
hazard. Contact the Einhell USA
service center at 1-866-EINHELL
(1-866-346-4355) for assistance.

8. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 12 -
customer
®
25.04.2019 13:50:36 25.04.2019 13:50:36