Starting Up The Software For The First Time; Starting Up The Software For The Second And Subsequent Times - Sony PCLK-MD2 Mode D'emploi

Starting up the software for the first time

Starting up the software for the second and subsequent times

16 GB
/ Click "Start," point to "Programs," point to "MD Editor
2," and then click "MD Editor 2."
This software is then started and the MD Editor 2 Main Bar
appears.
When you start the software, the following display appears:
If a dialog appears instead of the Main Bar, select a serial
port.
On the serial port selection dialog box, select one of options COM1,
COM2, COM3, and COM4 that is available for your computer. Also
check that the MD deck is connected to the serial port you selected.
Notes
• Set up the serial port that is to be used for this kit so that it is
unavailable to the other software.
• To verify that the serial ports of your computer are enabled, call the
vendor of your computer.
/ Click "Start," point to "Programs," point to "MD Editor
2," and then click "MD Editor 2."
The software is started and the MD Editor 2 Main Bar appears.
Notes
• Be sure to quit MD Editor 2 before turning off the MD deck.
• Do not use a bi-directional remote while MD Editor 2 is active.
• If an MD Editor 2-compatible component other than a CD player is
connected to the MD deck through the monaural (2P) mini-plug cord,
do not use any of the controls other than the volume control while
the MD deck is active. Using these controls may result in a
malfunction.