Hooking Up The Audio Components - Sony SCD-777ES Mode D'emploi

Hooking Up the Audio Components

Connect the Super Audio CD player to an audio
component. Be sure to turn off the power of all
components before making connections and connect
securely to prevent noise.
Connecting via ANALOG OUT jacks
Use an audio connecting cord for this connection. Be sure to
match the colour-coded pin to the appropriate jacks: white (left)
to white and red (right) to red.
Audio connecting cord (supplied)
White (L)
Red (R)
Connecting via DIGITAL OUT CD OPTICAL
connector
Use an optical digital cable for this connection. When connecting
the optical digital cable to the DIGITAL OUT CD OPTICAL
connector, take the cap off the connectors and push the cable
plugs in until they click into place.
Be sure to show "16 bit" in the display by pressing DIGITAL OUT
on the upper side of the player. Be careful not to bend or twist the
optical cable.
Optical digital cable (not supplied)
Note
Only the audio signals of the CD can be output from the
DIGITAL OUT CD connectors. Those of the Super Audio CD
cannot be output through DIGITAL OUT CD.
R
White (L)
Red (R)
COMMAND
MODE
CD1
CD2
ANALOG OUT
L
Stereo amplifier, etc.
INPUT
CD
L
R
Connecting via DIGITAL OUT CD COAXIAL
connector
Use a coaxial digital cable to connect the audio components
equipped with coaxial digital input connectors. When connecting
the coaxial digital cable, be sure to show "16 bit" in the display
by pressing DIGITAL OUT on the upper side of the player.
Coaxial digital cable (not supplied)
Note
Only the audio signals of the CD can be output from the
DIGITAL OUT CD connectors. Those of the Super Audio CD
cannot be output through DIGITAL OUT CD.
DIGITAL OUT
CD
COAXIAL
~AC IN
STANDARD
CUSTOM
TA - E1 / N1
OPTICAL
5
GB