Adjusting The Base Runner; Adjusting The Pendulum Stroke; Working With The Machine; Plunge Cutting Without Pilot Drilling - Festool TRION PS 300 Q Notice D'utilisation D'origine/Liste De Pièces De Rechange

Insert the extractor adapter into the rear
hole of the base runner in so that the hook
[2-6] catches in the notch [2-7].
Press the lever
tractor adapter.
7.6

Adjusting the base runner

The base runner can be swivelled to both
sides by up to 45° for bevel cuts.
Remove chip guard and splinterguard,
release locking screw
[1-4],
push base runner approx. 5 mm forwards,
set desired inclination according to the
scale [5-2],
tighten locking screw [4-1].
Für randnahes Sägen kann der Sägetisch
nach hinten versetzt werden
Remove chip guard and splinterguard,
release locking screw
[1-4],
push base runner to rear position so that
the centring pin
[5-3],
tighten locking screw [4-1].
7.7

Adjusting the pendulum stroke

In order to process different materials with
an optimum feed movement the pendulum
jigsaws have an adjustable pendulum stroke.
Select the desired setting with the pendulum
stroke switch [1-5]:
setting 0 = pendulum stroke off
setting 3 = maximum pendulum stroke
Recommended settings of the pendu-
lum stroke
Hard and soft wood,chip board,
wood fibre board
Wood core plywood, plywood, plas-
tics
Ceramic
Aluminium, NF metals
Steel
7.8 Adjusting the number of strokes
PS 300 EQ, PSB 300 EQ
You can regulate the number of strokes step-
lessly between 1000 and 2900 min
adjusting wheel
[1-2;
optimise the cutting speed to suit the mate-
rial.
[2-5] to remove the ex-
[4-1] with Allen key
[4-1] with Allen key
[5-1] fits in the opening
-1 using the
2-3]. This enables you to
Recommended number of strokes
(adjusting wheel setting)
Hard and soft wood, wood core ply-
wood, plywood, chip board
Wood fibre boards
Plastics
Ceramic, aluminium, NF metals
Steel
8

Working with the machine

Risk of injury
Always secure the workpiece in such a
manner that it cannot move while being
sawed.
8.1 Free hand according to the
scribe mark
The triangular shape of the splinterguard
3] shows the cutting line of the saw blade
and thus facilitates cutting to a scribe mark.
8.2 Plunge cutting without pilot
drilling
The base runner must be in the front position
for plunge cuts in timber materials (basic
setting, see Figure [1]).
Place saw on the front edge of the runner,
set saw to maximum no. of strokes and
pendulum stroke setting 3 and start the
plunge cut into the workpiece (Figure
[6]).
9

Service and maintenance

1 - 3
1 - 2
Risk of injury, electric shock
Always disconnect the mains plug from the
0
socket before performing maintenance
work on the machine!
0 - 2
All maintenance and repair work which re-
0 - 1
quires the motor housing to be opened
must only be carried out by an authorised
service workshop.
Damaged safety devices and components
must be repaired or replaced in a recognised
specialist workshop, unless otherwise indi-
cated in the operating manual.
TRION
WARNING
WARNING
GB
6
4 - 6
3 - 6
3 - 5
2 - 4
[4-
15