Intended Use; Preparation; Low Battery Indicator - Bosch GRL 240 HV Consignes De Fonctionnement/Sécurité

Rotational Laser Level
The measuring tool is intended for determining
and checking precise horizontal partitions, vertical
lines, building lines and plumb points.
The measuring tool is suitable for indoor and
outdoor use.
Working safely with the
!
WARNING
rotary laser is possible only
when the operating and
safety information are read completely and
the instructions contained therein are strictly
followed. Never make warning labels on the
rotary laser unrecognizable.
Use of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous
radiation exposure.
Inserting/Replacing the Battery
ALWAYS turn off the laser
!
WARNING
and the main power switch
before removing and replacing batteries.
Alkaline batteries are recommended for the
tool.
Always replace all batteries at the same
time. Use only batteries from one brand and
with the identical capacity.
Remove the batteries from the tool when not
using for extended periods. When storing for
extended periods, the batteries can corrode and
discharge themselves.
When inserting, pay attention to the correct
polarity according to the representation of
the inside battery lid.
It is the user's responsibility to periodically
check the accuracy of the measuring tool
as work progresses. Always check the
accuracy of the measuring tool after it
has been dropped or subject to extreme
temperatures and temperature variations.
To open the battery compartment 14, turn the
locking knob 15 to position
battery compartment.
Always replace all batteries at the same time.
Only use batteries from one brand and with the
identical capacity.

Intended Use

The use of optical instruments with this
product will increase risk of eye injury.
Have the rotary laser repaired only through
qualified specialist using original spare parts.
This ensures that the safety of the rotary laser is
maintained.
Do not allow children to use the rotary laser
without supervision. They could unintentionally
blind other persons.
Do not use the laser viewing glasses as
safety goggles. The laser viewing glasses are
used for improved visualization of the laser beam,
but they do not protect against laser radiation.
Do not use the laser viewing glasses as sun
glasses or in traffic. The laser viewing glasses
do not afford complete UV protection and reduce
color perception.

Preparation

Shut the battery compartment 14 and turn the
locking knob 15 to the
In case the batteries have been inserted
incorrectly, the measuring tool cannot be
switched on. Insert the batteries with
correct polarity.
Remove the batteries from the tool when not
using it for extended periods. When storing for
extended periods, the batteries can corrode and
discharge themselves.

Low Battery Indicator

When the charge-control indicator 12 flashes
red for the first time, the measuring tool can still
be operated for approx. 2 h.
When the charge-control indicator 12 lights
up red continuously, measurements are no
longer possible. The measuring tool switches off
automatically after 1 minute.
and pull out the
-9-
position.