Bosch GRL 240 HV Consignes De Fonctionnement/Sécurité page 21

Read and observe all instructions.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
• Have the remote control repaired only through a qualified repair person and
only using identical replacement parts. This will ensure that the functionality
of the remote control is maintained.
• Do not operate the remote control in explosive atmospheres, such as in the
presence of flammable liquids, gases or dusts. Sparks can be created in the
remote control which may ignite the dust or fumes.
• Read and strictly observe the safety warnings in the operating instructions
of the rotational laser.
7A
The remote control is intended for controlling rotational laser levels
6A
5A
4A
Inserting/Replacing the Battery
3A
Using alkali-manganese batteries is recom-
mended for operation of the remote control.
To open the battery lid 8A, press the latch 9A in
the direction of the arrow and remove the battery
2A
lid. Insert the battery provided.
1A
Remote control
1)
Working range
Operating temperature
Storage temperature
Battery
Weight according to
EPTA-Procedure 01/2003
1) The working range can be decreased by unfavorable environmental conditions (e.g. direct sun
irradiation).
Please observe the article number on the type plate of your remote control.
The trade names of individual remote controls may vary.
For clear identification of your remote control, see the serial number
RC1 General Safety Rules
10A
9A
8A
RC1 Intended Use
in indoor and outdoor use.
RC1 Preparation
RC1 Technical Data
-21-
When inserting, pay attention to the correct
polarity according to the representation on
the inside of the battery compartment.
• Remove the battery from the remote
control when not using it for longer
periods. When storing for longer periods, the
battery can corrode and discharge itself.
1 x 1.5 V LR06 (AA)
on the type plate.
10A
RC1
100 ft (30 m)
–10 °C ~ +50 °C
–20 °C ~ +70 °C
2.4 oz. (69 g)