Electrical Connection; Wiring Diagram - Cola TERMOPLUS 18 Manuel D'installation, D'utilisation Et D'entretien

2.5 Turbulator and baffle position check
Before lighting the stove make sure the brazier is in the correct position, i.e. fitted in the special slots. Also make
sure the turbulator shaker device is resting in a lower position. An incorrect position of the brazier and/or turbulators
can result in malfunctioning and excessive blackening of the glass.
At every stove lighting check the correct position of the brazier and turbulator shaker device.

2.6 Electrical connection

Connect one end of the power cable to the rear socket of the stove, and the other to the wall socket.
The voltage supplied by the system must match that specified on the stove dataplate and in the technical data
section of this manual.
During stove idle periods it is advisable to remove the power cable.
Make sure the electrical system is equipped with an earth and differential switch
in accordance with the current Regulations.
The power cable must never touch the stove exhaust pipe.

2.7 Wiring diagram

42 TERMOPLUS 18