MRA 4025066141524 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
2 Spacer 3mm
1 Edge protector
(only Racingscreen)
2 Crimping sleeve
(only Racingscreen)
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the 6 screws of the original motorcycle windshield.
3. Mount the MRA Motorcycle windscreen and use the supplied spacers.
4. Only Racingscreen: apply the edge guard profile to the exposed rear area of
the windshield, starting at the fairing transition and ending at the opposite
side. Cut off the rest if required
5. It is also possible to push the clamping sleeves over the ends of the
protective edge strip and lightly compress these using a pair of pliers to
secure the edge strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Kawasaki ZX10R 2011-
Article No..
--- Allen key 4mm
10634
3
Required tools