Discharging Nicd Or Nimh Batteries; Charge/Discharge Cycling Of Nicd/Nimh Batteries - HITEC multi charger X4 AC Plus Mode D'emploi

Professional Balance Charger, Discharger

8.1. Discharging NiCd or NiMH Batteries

Set the discharge current on the left and the voltage cutoff
on the right by pressing the „START/ENTER" key for more
than 3 seconds to start the program. Discharge current can
be set from 0.1-1.0 A and voltage cutoff from 0.1-25.0 V.
This screen indicates the discharging state. You can press
the „START/ENTER" key to alter the discharge current. Press
the „START/ENTER" key again to store the setting. Press
the „BATT TYPE/STOP" key to stop discharging. The charger
will emit a sound to indicate the end of the discharge process.

8.2. Charge/Discharge Cycling of NiCd/NiMH Batteries

Set the cycle sequence on the left and the number of cycles
on the right. The battery can be cycled 1-5 cycles.
Press the „BATT TYPE/STOP" key to stop the program then
press the „START/ENTER" key to alter the charge or discharge
current. A sound will indicate the end of the program.
When the charger approaches the end of the program cycle,
you can view the capacity of the battery being charged or
discharged. Use the „INC" or „DEC" keys to scroll through
the results of each cycle.
NIMH DISCHARGE
1.0A
– +
DEC INC DEC
Batt type Start
stop Enter
NiMH 0.1A
DSC 022:45 00890
Battery
Type
Elapsed Discharged
Time Current
NIMH
DCHG>CHG
– +
DEC INC DEC
Batt type Start
stop Enter
NIMH 1.0A 7.42V
D>C 022:45 00890
Battery
Type
Elapsed
Discharge or
Time
Charge Current
DCHG 1 1314mAh
CHG 1 1430mAh
11.5V
– +
INC
> 3 seconds
Battery
7.42V
Voltage
Discharged
Capacity
CYCLE
3
– +
INC
> 3 seconds
Battery
Voltage
Discharged or
Charged Capacity
43