IKRA BHS 60 Mode D'emploi page 27

1
2
Fig.12
Fig.11
1 2
3
3
Fig.13
OPERA TING MANUAL
STOP ENGINE
1) To stop the engine, shut the power switch (fig. 11
part. 1) "OFF".
CAUTION! Familiarise yourself with the
operation of the throttle lock in order to act
quickly in case of an emergency.
CAUTION! The blades continue to move
for a while after the throttle lever is released.
WARM ENGINE STARTUP
Follow the instruction given for cold engine startup,
but with the choke lever in position
7. OPERATION
Always grip the machine with both hands. Op-
erate by opening the throttle lever to maximum.
CUTTING THE TOP OF THE HEDGE
A) Keep the machine in a horizontal position (fig. 3).
B) The rear handle in a vertical position.
C) For safety reasons, do not use the machine above
shoulder height.
CUTTING THE SIDES OF THE HEDGE
A) For a vertical cut, move the rear handle into a
comfortable position for the hand and arm. Hold the
front handle with the side grip (see fig. 4)
POSITION OF THE REAR HANDLE
B) To change the inclination of the rear handle:
1) Release the throttle lever (fig.5 part.1)
2) Engage the rotation lock control (fig. 5 see arrow
A). Rotate the handle (fig. 5 see arrow B), until the
required angle is obtained.
GB
.
GB-4