Thermador Professional PRO-HARMONY PRD30 Manuel D'installation page 26

• Use three (3) Torx head screws to install the guard strip on the back of the
range, as shown in the illustration. The strip is not needed on 48" ranges.
The center of the strip may be supported by a tab from the back panel, and not
require a screw.
• To secure the front of the back guard, install three (3) of the Torx head screws
through the lower front panel of the backguard, into the flange at the back of the
range's cooktop.
• The Pot-and-Pan Shelf models provide a shelf above the cooktop to keep foods
hot or store cooking pans. OBSERVE CAUTIONS CONCERNING ITEMS
PLACED ON TOP OF THE SHELF.
CAUTION
The Pot and Pan Shelf can get very hot!
DO NOT place the following items on top of the Pot and Pan Shelf:
• plastics or containers that can melt
• flammable items
• a total load over 30 pounds (13.6kg)
Chart C: Backguard Kit Model Numbers
Model 6" Std.
Low Back
Included with
30"
Range
36" N/A
48" N/A
9" Low 22" Pot and
Back Pan Shelf
N/A PAD30EHSH
PAD36ELBH PAD36EHSH
PAD48ELBH PAD48EHSH
3" Island
Trim
PAD30EITH
PAD36EITH
PAD48EITH
Page 23