Descaling - Bosch TASSIMO JOY TAS 43 Série Mode D'emploi

28

Descaling

! ! Important:
– If you have very hard water, notice
an unusual amount of steam or if the
beverage size is not what it should
be, descale the machine before the
Q
LED comes on.
– Do not drink any of the liquids used for
descaling.
– Never use vinegar or vinegar­based
products.
– Never interrupt the descaling
programme.
1.
3.
Robert Bosch Hausgeräte GmbH
2.
4.
Your TASSIMO machine must be descaled
regularly, because heating water creates
limescale which accumulates in the machine
over time. When descaling is needed, the
machine indicates this by activating the
"Descale required"
this LED lights up, you should descale
your machine immediately. Not doing so
may result in the machine not functioning
properly and beverage quality deteriorating.
If you have not descaled the machine after
another 20 T DISCs, the indicator starts to
blink.
Special!descaling!agents!can!be!
obtained!from!www.tassimo.com,!the!
Bosch!customer!service!department!
(article!no.!310967,!for!contact!details,!
see!page!166)!or!from!your!retailer.
Running!the!descaling!programme
1.! Take off the water tank (5).
2.! Remove the Service T DISC (6a) from
the compartment (6) behind the water
tank.
3.! Fill the water tank up to the descaling
mark "0,5 l" (5b) and add the descaling
agent in accordance with the
manufacturer's instructions.
i ¡
Note:
If you have hard water, increase the
amount of the descaling agent.
4.! Replace the water tank by slanting it
slightly and returning it to its original
position until it clicks into place.
'
LED (3c). When
en