Bosch TASSIMO JOY TAS 43 Série Mode D'emploi page 31

en
5.
500 ml
7.
5 sec.
! ! Important:
The descaling programme runs for
approximately 20!minutes.
8.
6.
20!min.
5.! Place a container with a capacity of at
least 500 ml under the drink outlet (4d).
6.! Open the brewing unit (4) by lifting
the handle (4a) and then pushing the
brewing unit up. Place the Service
T DISC (6a) on the T DISC holder (4b)
with the barcode facing down. Make
sure that the flap of the T DISC is
located in the slot in the front.
Close the brewing unit by first bringing
►
it down and then pushing the handle
firmly into the machine, until you hear
an audible click.
7.! Press and hold the Start / Stop button
(2) for at!least!5!seconds to start the
descaling programme.
Release the Start / Stop button after
►
5 seconds; the machine will run the
descaling cycle automatically. This is
indicated by the Status LED
"Descale required" LED
i ¡
Note:
The descaling solution is pumped through
the machine in intervals and then runs
into the container until the water tank (5) is
almost empty. A small amount of liquid is
always left in the tank.
8.! When the Status LED
required" LED
descaling process is complete. Empty
the receiving container and return it
under the drink outlet.
Rinse the water tank thoroughly and
►
fill up to the max mark with fresh cold
water.
Replace it back onto your TASSIMO
►
machine.
F
(3a) and
'
(3c) blinking.
F
and "Descale
'
stop blinking, the
29
01/2013