MultiSync LCD1990FXP Manuel D'utilisation page 14

Controls
AccuColor
AccuColor Control Systems: Six color presets select the desired color setting
(sRGB and NATIVE color presets are standard and cannot be changed).
R,G,B: Increases or decreases Red, Green or Blue color depending upon which
is selected. The change in color will appear on screen and the direction (in-
crease or decrease) will be shown by the bars.
NATIVE: Original color presented by the LCD panel that is unadjustable.
sRGB: sRGB mode dramatically improves the color fidelity in the desktop
environment by a single standard RGB color space. With this color supported
environment, the operator could easily and confidently communicate color
without further color management overhead in the most common situations.
Tools
DVI SELECTION: This function selects the DVI input mode. If the DVI selections
changes, you must restart the computer.
DIGITAL: DVI digital input is available.
ANALOG: DVI analog input is available.
NOTE: When using a MAC with digital output: before turning on the
MAC, the DVI Input mode on the monitor must be set to DIGITAL in the DVI
SELECTION menu. To set the DVI SELECTION to "DIGITAL" press the SELECT
button then CONTROL button when the DVI signal cable is connected to the
DVI-I connector of the monitor. Otherwise the MAC may not turn on.
VIDEO DETECT: Selects the method of video detection when more than one
video input source is connected to the monitor.
FIRST: If "FIRST" is selected as the VIDEO DETECT option, the
monitor displays the signal from the first input port. If there is no signal present
at the first input port, then the monitor will search for a signal from the next
input port.
If a new input signal is connected to another of the monitor's input ports while
the monitor is in FIRST mode, the monitor DOES NOT automatically
SWITCH to the new source.
NONE: The monitor will only search other input ports while the power is on.
– continued
Control Systems
®
12