HQ Power VDSSM3 Mode D'emploi page 6

If an unbalanced input signal is to be connected using an XLR plug, a wire
bridge must be inserted between pin 1 and pin 3. For an unbalanced signal
input, a 6.35mm mono jack plug may also be used.
For the ''turnlock'' connectors, connection must be made as shown, using
a professional connector (type CAS101).
SETUP
Mono Setup (fig. 3)
Feed the signal from the mixer to
a balanced XLR input socket of
the system. Connect the other
input socket by means of the
through. Next, use appropriate
loudspeaker cables to connect
the satellites to the subwoofer.
CAUTION: The satellite outputs are designed for a nominal impedance of 8 ohms. Under no circumstances may the
impedance dip below this value. Else, the power amplifier may suffer serious damage.
Stereo Setup (fig. 4)
Feed the signal from the mixer to
the balanced XLR input sockets
of the system. Next, use
appropriate loudspeaker cables
to connect the satellites to the
subwoofer.
Dual Configuration (fig. 5)
The dual configuration consists of two VDSSM3 systems.
TRANSPORTATION
To transport the system, simply set the subwoofer on its casters and place the
satellites onto the subwoofer with the acoustic foam grille facing down. Secure the
satellites to the subwoofer with a locking strap. Protect the system by applying the
dust cover over the complete set.
VDSSM3 6 VELLEMAN