Maintenance And Inspection - HIKOKI UC36YRSL Mode D'emploi

NOTE
The recharging time may vary according to the
ambient temperature and power source voltage.
4. Disconnect the charger's power cord from the
receptacle.
5. Hold the charger fi rmly and pull out the battery or
adaptor of back pack power supply.
NOTE
○ Be sure to pull out the battery from the charger after
use, and then keep it.
○ When the back pack power supply is not in use, switch
it OFF.
CAUTION
○ If the battery and back pack power supply are charged
while it is heated because it has been left for a long
time in a location subject to direct sunlight or because
the battery and back pack power supply have just
been used, the pilot lamp of the charger lights up
green. In such a case, fi rst let the battery and back
pack power supply cool, then start charging.
○ When the pilot lamp fl ickers in red (at 0.2-seconds
intervals), check for and take out any foreign objects in
the charger's battery connector. If there are no foreign
objects, it is probable that the battery, back pack
power supply or charger is malfunctioning. Take it to
your authorized Service Center.
○ Since the built-in microcomputer takes about 3
seconds to confi rm that the battery and back pack
power supply being charged with UC36YRSL is
taken out, wait for a minimum of 3 seconds before
reinserting it to continue charging. If the battery is
reinserted within 3 seconds, the battery and back
pack power supply may not be properly charged.

MAINTENANCE AND INSPECTION

1. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws
be loose, retighten them immediately. Failure to do so
could result in serious hazard.
2. Cleaning of the charger
When the charger is stained, wipe with a soft dry cloth
or a cloth moistened with soapy water. Do not use
chloric solvents, gasoline or paint thinner, for they melt
plastics.
3. Store idle charger
When not in use, the charger should be stored in dry,
high or locked-up place — out of reach of children.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
11
English