Table des Matières
Publicité
Cleaning
Regular cleaning ensures better shaving performance. Rinsing the shaver head
after each shave under running water is an easy and fast way to keep it clean:
• Switch on the shaver (cordless) and rinse the shaver head under hot running
water until all residues have been removed. A natural based soap may also be
used provided it contains no particles or abrasive substances. Rinse off all
foam and let the shaver run for a few more seconds.
• Next, switch off the shaver and press the foil release buttons (3). Remove the
shaver foil and the cutter block. Then leave the disassembled shaving parts to
dry.
Alternatively, you may clean the shaver using the brush provided:
• Switch off the shaver. Remove the shaver foil and tap it out on a flat surface.
Using a brush, clean the inner area of the shaver head. However, do not clean
the shaver foil nor the cutter block with the brush as this will damage them.
Keeping your shaver in top shape
If you regularly clean the shaver under water, then once a week apply a drop of
light machine oil onto the long hair trimmer and shaver foil.
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the
shaver has to be fully discharged (by shaving) every 6 months approximately.
Then recharge the shaver to full capacity.
Replacing the shaving parts
To maintain 100% shaving performance replace your foil and cutter block at least
every 18 months or when worn. Change both parts at the same time for a closer
shave with less skin irritation.
(Shaver foil and cutter block: 30B)
Environmental notice
Product contains batteries and/or recyclable electric waste. For environ-
ment protection do not dispose of in household waste, but for recycling
take to electric waste collection points provided in your country.
Subject to change without notice.
Electric specifications see printing on the special cord set.
10
Publicité
Table des Matières
