Operation; Safe Operation - Hilti WSR 900-PE Mode D'emploi

6.3 Adjusting the contact shoe
The contact shoe can be adjusted to ensure optimum
use of the blade length and to improve access in cor-
ners.
1. Unplug the supply cord from the electric socket.
2. Remove the saw blade (see 6.2).
3. Press the contact shoe lockbutton and hold it in this
position.
4. Slide the contact shoe forward or back into the desired
position.
5. Release the lockbutton.
6. Pull on the contact shoe to check that it has engaged.
6.4 Using the pipe cutting adaptor
(accessory)
1. Unplug the supply cord from the electric socket.
2. Remove the saw blade (see 6.2).
3. Press the contact shoe lockbutton and hold it in this
position.
4. Pull the contact shoe away from the tool toward the
front.
5. Push the pipe cutting adaptor into the tool from the
front until it is in the desired position.

7. Operation

The cutting edges of the saw blade
●
are sharp.
The cutting edges may present a risk
●
of injury.
Wear protective gloves.
●
The sawing operation swirls up dust
●
and wood chips into the air.
The dust and wood chips may be harm-
●
ful to the eyes and respiratory system.
Wear protective goggles and breath-
●
ing protection.
Operation of the tool creates noise.
●
Excessive noise may damage the
●
hearing.
Wear ear protection.
●
Printed: 21.08.2013 | Doc-Nr: PUB / 5138031 / 000 / 01
-CAUTION-
-CAUTION-
-CAUTION-
6. Release the lockbutton.
7. Pull on the pipe cutting adaptor to check that it has
engaged.
8. Open the screw clamp to the maximum position.
9. Place the adapter chain around the pipe, locking the
chain to the fitting.
-NOTE- The handle should be at a 45° angle.
6.5 Fitting the side handle (accessory)
1. Unplug the supply cord from the electric socket.
2. Remove the saw blade (see 6.2).
3. Place the adaptor around the front grip section from
above and close the adaptor.
4. Slide the side handle onto the adaptor from the front.
5. Secure the side handle by turning the screw knob on
the handle.
6.6 Positioning the side handle (accessory)
1. Unplug the supply cord from the electric socket.
2. Slacken the screw knob on the side handle.
3. Bring the side handle into the desired position.
4. Secure the side handle by turning the screw knob on
the handle.
-NOTE-
To ensure good cutting performance and ease the load
●
on the tool, use only saw blades that are in good con-
dition.
Do not overload the tool.
●
-CAUTION-
When working, always guide the tool away from the
●
body.
Lift the tool away from the workpiece only once the
●
blade has come to a standstill.
Do not lay the tool down before the blade has come
●
to a standstill.
The saw blade becomes hot when
●
used for long periods.
There is a risk of burning if the blade
●
is touched.
Wear protective gloves.
●

7.0 Safe operation

-DANGER-
The power tool must be pressed against the workpiece
until the contact shoe makes firm contact. This helps
ensure maximum safety and good performance.
-CAUTION-
19
en