Fitting The Battery; Removing The Battery; Operation; Changing The Saw Blade - Hilti WSC 7.25-A36 Mode D'emploi

6.3 Fitting the battery

DANGER
Use only the Hilti batteries and Hilti chargers listed
under "Accessories".
CAUTION
Check that the power tool is switched off and the
switch interlock activated before fitting the battery.
Use only the Hilti batteries approved for use with this
power tool.
1. Push the battery into the power tool from the rear as
far as it will go and until it is heard to engage with a
double click.
2. CAUTION A falling battery may present a risk of
injury to yourself and others.
Check that the battery is seated securely in the
power tool.

7 Operation

NOTE
If the blade is stalled for a long time, the tool will not
restart by itself when the pressure applied to it is released.
The switch-on interlock and the on/off switch must be
pressed again.
CAUTION
Wear protective gloves. The cutting edges of the saw
blade teeth are sharp. The cutting edges may present a
risk of injury.
CAUTION
Wear protective glasses and a dust mask. The sawing
operation swirls up dust and wood chips into the air. The
dust and wood chips may be harmful to the eyes and
respiratory system.
CAUTION
Wear ear protectors. The power tool and the sawing
operation generate noise. Exposure to noise can cause
loss of hearing.

7.1 Changing the saw blade

CAUTION
Wear protective gloves when changing insert tools.
The blade, the clamping flange and the clamping screw
get hot.

6.4 Removing the battery

1. Press one or both release buttons.
2. Pull the battery out of the power tool toward the
rear.
6.5 Transport and storage of batteries
Pull the battery out of the locked position (working posi-
tion) and move it into the first click-stop position (trans-
port position).
If you disconnect a battery from the power tool for trans-
port or storage, make sure that the battery contacts are
not short-circuited. Remove loose metal parts such as
screws, nails, clamps, loose screwdriving bits, wires or
metal swarf from the case, toolbox or transport container,
or prevent these parts from coming into contact with the
battery.
Observe national and international transport regulations
when shipping batteries (transportation by road, rail, sea
or air).
CAUTION
Check that the blade to be fitted complies with the
technical requirements and that it is well sharpened. A
sharp saw blade is an essential requirement for a perfect
cut.
7.1.1 Removing the saw blade 2
1. Pull the battery out of the power tool.
2. Press the drive spindle lockbutton.
3. Turn the saw blade clamping screw with the hex.
socket wrench until the locking pin engages fully.
4. Use the hex. socket wrench to release the clamping
screw by turning it counterclockwise.
5. Remove the clamping screw from the outer clamping
flange.
6. Open the pivoting guard by swinging it to the side
and then remove the saw blade.
7.1.2 Fitting the saw blade 3
1. Pull the battery out of the power tool.
2. Clean the mounting flange and the clamping flange.
3. Fit the mounting flange.
4. Open the pivoting guard.
5. CAUTION Observe the direction-of-rotation ar-
row on the saw blade.
Fit the new saw blade.
6. Fit the outer clamping flange.
7. Secure the clamping flange by tightening the clamp-
ing screw in a clockwise direction. When doing so,
press the spindle lockbutton as before (see "Re-
moving the blade").
8. Before using the power tool, check that the saw
blade is securely attached.
en
9