Operation; Changing The Saw Blade - Hilti WSC 7.25-S Mode D'emploi

6 Operation

en
CAUTION
Wear protective gloves. The cutting edges of the saw
blade teeth are sharp. The cutting edges may present a
risk of injury.
CAUTION
Wear protective glasses and a dust mask. The sawing
operation swirls up dust and wood chips into the air. The
dust and wood chips may be harmful to the eyes and
respiratory system.
CAUTION
Wear ear protectors. The power tool and the sawing
operation generate noise. Exposure to noise can cause
loss of hearing.

6.1 Changing the saw blade

CAUTION
Wear protective gloves when changing blades. The
blade, the clamping flange and the clamping screw get
hot.
CAUTION
Check that the blade to be fitted complies with the
technical requirements and that it is well sharpened. A
sharp saw blade is an essential requirement for a perfect
cut.
6.1.1 Removing the saw blade 3
1. Disconnect the supply cord plug from the power
outlet.
2. Press the drive spindle lockbutton.
3. Turn the saw blade clamping screw with the hex.
socket wrench until the locking pin engages fully.
4. Use the hex. socket wrench to release the clamping
screw by turning it counterclockwise.
5. Remove the clamping screw from the outer clamping
flange.
6. Open the pivoting guard by swinging it to the side
and then remove the saw blade.
6.1.2 Fitting the saw blade
1. Disconnect the supply cord plug from the power
outlet.
2. Clean the mounting flange and the clamping flange.
3. Fit the mounting flange.
4. Open the pivoting guard.
8
All manuals and user guides at all-guides.com
5.
6.
7.
8.
6.2 Adjusting the cutting depth 4
NOTE
The cutting depth should always be set to a depth approx.
5 to 10 mm greater than the thickness of the material to
be cut.
The cutting depth can be adjusted stepplessly between
0 and approx. 70 mm.
1.
2.
3.
4.
6.3 Adjusting the cutting angle 5
The saw can be set to any angle between 0 and 56º for
bevel cuts.
6.3.1 Presetting the bevel cutting angle
3 preset angles are possible: 22.5º, 45º and 56º.
1.
2.
3.
4.
5.
6.
6.3.2 Setting the bevel cutting angle without
1.
2.
3.
4.
CAUTION Observe the direction-of-rotation ar-
row on the saw blade.
Fit the new saw blade.
Fit the outer clamping flange.
Secure the clamping flange by tightening the clamp-
ing screw in a clockwise direction. When doing so,
press the spindle lockbutton as before (see "Re-
moving the blade").
Before using the power tool, check that the saw
blade is securely attached.
Disconnect the supply cord plug from the power
outlet.
Place the power tool on a supporting surface.
Release the cutting depth adjustment clamping lever
The set cutting depth is indicated by the arrow on
the scale on the gear housing.
Lift the power tool in a scissor movement and set
the desired cutting depth by closing the clamping
lever.
Disconnect the supply cord plug from the power
outlet.
Release the cutting angle adjustment clamping
lever.
Pivot the base plate to the 0° position.
Set the preset angle indicator to the desired angle.
Pivot the base plate as far as it will go.
Tighten the cutting angle adjustment clamping lever.
presetting
Disconnect the supply cord plug from the power
outlet.
Release the cutting angle adjustment clamping
lever.
Pivot the base plate to the desired angle setting.
Tighten the cutting angle adjustment clamping lever.