Pioneer DJM-2000 Mode D'emploi page 10

to the computer's USB port. Wait until the [Your devices are ready for use]
message appears.
! When installing on Windows XP
— [Can Windows connect to Windows Update to search for software?]
may appear while the installation is in progress. Select [No, not this
time] and click [Next] to continue with the installation.
— [What do you want the wizard to do?] may appear while the instal-
lation is in progress. Select [Install the software automatically
(Recommended)] and click [Next] to continue with the installation.
— If [Windows Security] appears on the screen while the installation is in
progress, click [Install this driver software anyway] and continue with
the installation.
Switching the input/ output setting
Use this procedure to switch the computer's input/ output setting when using the
driver software.
! If applications using this unit as the default audio device (DJ applications,
etc.) are running, quit those applications before switching the input/ output
setting.
! Some time is required after the input/ output setting is switched for the com-
puter to be updated. The input/ output setting cannot be switched while the
computer is being updated.
! Sound may not be output if there are differences between the input/ output
settings on this unit and on the computer. If this happens, turn this unit's
power on and reset the input/ output settings with the USB cable connected.
! If the input/ output setting is switched while using DirectX, the application
may not recognize the driver software.
! MIDI communications are interrupted if the input/ output setting is switched
during MIDI communications.
 Switching procedure (Windows)
Click the Windows [Start] menu> [All Programs] > [Pioneer] > [DJM-
2000] > [DJM-2000 Setting Utility].
Switch the computer's input/ output setting.
— ASIO 4 outputs 0 inputs 16 bits DirectX 1 output 0 inputs
— ASIO 3 outputs 1 input 16 bits DirectX 1 output 1 input
— ASIO 3 outputs 0 inputs 24 bits DirectX 1 output 0 inputs
 Switching procedure (Macintosh)
Click [Apple] > [System Preferences] > [Other] > [DJM-2000 Settings].
Switch the computer's input/ output setting.
— 8-channel output No input 16 bits
— 6-channel output 2-channel input 16 bits
— 6-channel output No input 24 bits
Adjusting the buffer size (Windows)
Use this procedure to adjust the computer's buffer size when using ASIO driver
software.
Click the Windows [Start] menu> [All Programs] > [Pioneer] > [DJM-
2000] > [DJM-2000 Setting Utility].
A sufficiently large buffer size decreases the chance of sound dropout (sound
interruption) but increases audio signal transmission delay (latency).
! If applications using this unit as the default audio device (DJ applications,
etc.) are running, quit those applications before adjusting the buffer size.
Checking the version of the driver software
 Procedure for checking (Windows)
Click the Windows [Start] menu> [All Programs] > [Pioneer] > [DJM-
2000] > [DJM-2000 Version Display Utility].
The [Version] screen appears.
 Procedure for checking (Macintosh)
Click [Apple] > [About This Mac] > [More Info] > [Extensions] > [DJM-
2000 USBAudio].
The [Version] screen appears.
10
En
Checking the latest information on the driver
software
For the latest information on the driver software for exclusive use with this unit,
visit our website shown below.
http://www.prodjnet.com/support/