Abus TVCC91500 Manuel Utilisateur page 36

RETURN
MOTION DET
Function
MOTION DET
DETECT SENSE
INTERVAL
BLOCK DISP
MASK AREA
MONITOR AREA
RETURN
SYS MODE
Function
SYNC MODE
LENS
FLIP
ON: Mosaic view of the area activated
Back to the previous menu page
Description
Settings for the motion detection function. The alarm output is activated
when a change in the image is detected.
OFF Function deactivated
ON: Function activated
(0-127): Sensitivity setting for motion detection
(0-127): Detection interval. A higher value increases the time until the
next detectable event
OFF: Live display of image changes deactivated
ON: Live display of image changes activated (block view of the
detected area)
(1-96): A blue marking means the motion detection area is activated.
AREA SEL (1-4): Selection of the motion area for configuration
AREA MODE (OFF, ON):
OFF: Motion area deactivated
ON: Motion area activated
TOP (0-15): Setting for the upper limit of the area
BOTTOM (0-15): Setting for the lower limit of the area
LEFT (0-15): Setting for the left limit of the area
RIGHT (0-15): Setting for the right limit of the area
Back to the previous menu page
Description
Image synchronisation settings
INT: Internal synchronisation
LL: When using a 24 V AC power supply, LINE LOCK (LL) can be used.
AUTO: Automatic detection of lens type
TYPE (DC, VIDEO):
MODE (AUTO, OPEN, CLOSE): Iris setting
ADJUST: Auto iris calibration
SPEED (0-255): Iris control speed
MANUAL: Manual iris setting
Image mirroring function
OFF: Function deactivated
V: Vertical image mirroring
H: Horizontal image mirroring
HV: Horizontal and vertical image mirroring
36
Manual selection between voltage-
controlled (DC) or video signal-
controlled lens type
AUTO: Automatic mode
OPEN: Iris fully open
CLOSE: Iris closed
English