Abus TVCC91500 Manuel Utilisateur page 24

Explanation of symbols
The triangular high voltage symbol is used to warn of the risk of injury or health
hazards (e.g. caused by electric shock).
The triangular warning symbol indicates important notes in this user guide which must
be observed.
This symbol indicates special tips and notes on the operation of the unit.
Important safety information
All guarantee claims are invalid in the event of damage caused by non-compliance with
this user guide. We cannot be held liable for resulting damage.
In the event of material or personal damage caused by improper operation or non-
compliance with the safety information, we cannot be held liable. All guarantee claims
are void in such cases.
The following safety information and hazard notes are not only intended to protect your health, but
also to protect the device from damage. Please read the following points carefully:

There are no components inside the product that require servicing. Dismantling the product
invalidates the CE certification and the guarantee / warranty.

The product may be damaged if it is dropped, even from a low height.

Install the device so that the image sensor is not subjected to direct sunlight. Pay attention to the
installation instructions in the corresponding section of this user guide.

The device is designed for indoor use. For outdoor use, an appropriate outdoor housing must be
used.
Avoid the following adverse conditions during operation:

Moisture or excess humidity

Extreme heat or cold

Direct sunlight

Dust or flammable gases, vapours, or solvents

Strong vibrations

Strong magnetic fields (e.g. next to machines or loudspeakers)

The camera must not be installed on unstable surfaces
General safety information:

Do not leave packaging material lying around. Plastic bags, sheeting, polystyrene packaging, etc.,
can pose a danger to children if played with.

The surveillance camera contains small parts which could be swallowed, and should be kept out of
reach of children for safety reasons.

Do not insert any objects into the device through the openings.

Only use replacement devices and accessories that are approved by the manufacturer. Do not
connect any non-compatible products.

Please pay attention to the safety information and user guides for the other connected devices.

Check the device for damage before commissioning. Do not put the device into operation if you detect
any damage.

Adhere to the operating voltage limits specified in the technical data. Higher voltages could destroy
the device and pose a health risk (electric shock).
24
English