AEG CDP 4201 Mode D'emploi page 53

Headphones - Remote Control (ABB. 3)
A. PHONES
B. HOLD OFF/ON
C. PLAY/PAUSE
D. VOLUME
E. STOP/OFF
F. I BACK
G. I NEXT
H. ESP/LR/DIR
Note: Some keys are to be found both on the device
itself and on the remote control. Keys with the same
designation have the same function.
In order to use the headphone remote control, please
proceed as follows:
Connect the plug of the headphone remote control to the
socket (11) on the device and then insert the plug of the
headphones/earphones into the connection socket (A).
Messages in the Display (ABB. 4)
1 VCD / MP3 / CD Format
2 Track number
3 Playing time
4 Button lock display
5 ESP function
6 Battery replacement display
7 RAN - RANDOM function
8 PGM - PROGRAMM function
9 REP - Single repeat
10 REP ALL - All repeat
11 REP DIR - Album repeat
Initial Use of the Device
Inserting the Batteries (not supplied)
• Open the battery compartment (17) on the back.
• Insert two 1.5 V batteries of type AA. Ensure the
correct polarity (see the bottom of the battery compart-
ment or the imprint on the outside).
• If the device is not used for a prolonged period, please
remove the batteries in order to avoid the leakage of
battery acid.
• A battery symbol in the display indicates that the bat-
teries need to be replaced. Always replace a complete
set of batteries and not just one.
Note: Batteries should not be disposed of in the domestic
waste. Please return used batteries to the appropriate
collection points or the dealer where you bought them.
Batteries must never be thrown into a fi re.
05-CDP 4201 NEU4 ohneCK 53
Batteries in the Remote Control
The battery in the remote control is a long-life lithium cell. If
the range of the remote control decreases, please proceed
as follows:
• Open the battery compartment on the side of the
remote control.
• Replace the cell with a battery of the same type.
Ensure the correct polarity.
• Close the battery compartment.
Mains Operation
It is possible to operate the device using the mains power
unit.
1. Insert the plug of the power unit into a correctly
installed 230V, 50 Hz wall socket.
2. Connect the CD player to the power unit by inserting
the plug of the power unit into the DC 4.5 V socket.
3. When using a power unit (DC 4.5V/700mA) ensure the
correct polarity according to the inscriptions on the CD
player.
General Operation
AUDIO/ Switches between loudspeaker set-
tings: MONO L, MONO R, STEREO
(only in VCD mode).
EQ (4): Various sound modes are available
(CLASSIC, DISCO, POP, JAZZ).
CHARGE
ON/OFF (16): Switches on the charge function
when the external power unit is
connected.
Warning! Please ensure that
there are no batteries inserted into
the battery compartment, as other-
wise there is a danger of explosion!
Only the correct rechargeable
batteries should be used!
Note: Please use the charging
sleeve supplied to make the contact
with the battery.
HOLD (15): This blocks the functions of all keys
on the device and is intended to
protect against a key being activated
accidentally. When the switch is
pushed to the right the word "HOLD"
appears in the display.
VOLUME (10): This is used to control the volume
(19/23 on the remote control). In
VCD mode this can only be adjusted
using the remote control or on the
television set itself.
53
06.09.2005, 9:01:25 Uhr