Adjusting The Sound Characteristics; Attenuating The Sound; Changing The Sound And Display Settings - Sony CDX-M610 Mode D'emploi

Adjusting the sound
characteristics
You can adjust the bass, treble, balance, and
fader.
You can store the bass and treble levels
independently for each source.
1
Select the item you want to adjust by
pressing (SOUND) repeatedly.
Each time you press (SOUND), the item
changes as follows:
BAS (bass) t TRE (treble) t BAL (left-right)
t FAD (front-rear) t SUB (subwoofer)
2
Adjust the selected item by pressing <
or ,.
When adjusting with the rotary
commander, press (SOUND) and rotate the
VOL control.
Note
Adjust within three seconds after selecting the
item.

Attenuating the sound

Press (ATT) on the card remote
commander or rotary commander .
"ATT on" appears momentarily.
To restore the previous volume level, press
(ATT) again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes
in (Telephone ATT function).
22
Changing the sound and
display settings
The following items can be set:
Set (Setting)
•Clock (page 9)
•Beep — to turn the beeps on or off.
•RM (Rotary Commander) — to change the
operative direction of the controls of the
rotary commander.
— Select "norm" to use the rotary
commander as the factory-set position.
— Select "rev" when you mount the rotary
commander on the right side of the
steering column.
•English/French/Spanish — to change the
display language to English, French, or
Spanish.
Dis (Display)
•D.Info (Dual Information) — to display the
clock and the play mode at the same time (on)
or to display the information alternately (off).
•SA (Spectrum Analyzer) — to change the
display pattern of the equalizer display
(page 24).
•Dimmer — to change the brightness of the
display (When the illumination cord
connected).
— Select "Auto" to dim the display only
when you turn the lights on.
— Select "on" to dim the display.
— Select "off" to deactivate Dimmer.
•Contrast — to adjust the contrast if the
indications in the display are not
recognizable because of the unit's installed
position.
•M.Dspl (Motion Display) — to turn the
motion display on or off.
•A.Scrl (Auto Scroll) (page 11)