Operating Your Device; Turning On Your Unit; Setting The Network Standby Control; Setting The Network Setup - Sherwood WD-1 Guide D'utilisation

Operating Your Device

Turning on Your Unit

1
Turn on the main unit by pressing
POWER ON.
2
Turn off the standby mode by pressing
STANDBY.
Setting the Network
Standby Control
1
Press and hold SETUP for more than 3
seconds.
When the Network Standby Control is
turned on, the status LED on the front
panel flashes two times.
2
To turn off the Network Standby Control,
press and hold SETUP for more than
3 seconds again.
When the Network Standby Control is
turned off, the status LED on the front
panel flashes three times.
Note
• When the Network Standby Control is
turned on, the power consumption may
increase.
12
Setting the Network
Setup
To listen to Internet radio stations or music files
stored on your computer via a wired or wireless
network, you should configure network settings
first.
1
Press SETUP.
2
Press  or  to navigate up or down the
menu.
3
Press ENTER to confirm the desired
menu. Press RETURN to move to the
previous menu.