Connecting Power - Sherwood WD-1 Guide D'utilisation

Note
• After making a broadband internet
connection, you should set the
communication settings. For details, see
"Setting the Network Setup" on page 12.
• When using a broadband internet
connection, a contract with an internet
service provider is required. For more
information, contact local internet service
provider.
• Since the connected equipment and
connection method may differ depending
on your internet environment, refer to the
operating instructions of the equipment.

Connecting Power

Make sure to plug in after you have connected
all your components to the main unit. Plug the
supplied AC input cord into the AC inlet and
then into the wall AC outlet.
To the Wall Outlet
Caution
• The supplied AC adapter is designed
exclusively for use with this unit. Do not
attempt to use it with any device for which
was not expressly designed, since fires
or shocks may occur.
• Handle the power cord by the plug part.
Do not pull out the plug by tugging the
cord, and never touch the power cord
when your hands are wet, as this could
cause a short circuit or electric shock.
• The main unit should be disconnected
by removing the main plug from the wall
outlet when not in regular use for a long
period of time.
Making Connections
11