Cable Management - CHIEF STS1 Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STS1
5.
Attach STS1 to mounting surface using 5/32" hex key (L)
and four 1/4-20 x 3-1/4" button head cap screws (E), four
flat 1/4" flat washers (G), four 1/4" fender washer (H), and
four 1/4" Nylock nuts (F). (See Figure 4)
6.
Lower STS1 base cover.
(E) x 4
5
Mounting
surface
(H) x 4
Figure 4
Attaching Display
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display. Properly sized
screws will easily and completely thread into display
mounting holes. If spacers are required, be sure to use longer
screws of the same diameter.
1.
Select correct screws, spacers (if necessary) from the
hardware bag (J) and attach STS1 to back of display. (See
Figure 5)
Display
(JD or JE, if required) x 4
Figure 5
6
(G) x 4
(F) x 4
(JA, JB or JC) x 4
1

Cable Management

1.
Run power cables from display to the back of the STS1.
2.
Lay power cables down back and through bottom of STS1,
and through mounting surface.
3.
Add wire cover (B) to back of STS1 by sliding it into the
STS1 through the top. (See Figure 6)
4.
Add top cap (C) to top of STS1. (See Figure 6)
5.
Add base cable plug (D) to STS1 base. (See Figure 6)
(Display removed for clarity)
3
(B)
Figure 6
Installation Instructions
4
(C)
Cable
Cable path
(D)
5

Publicité

Table des Matières
loading

Table des Matières