Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Adjustments
Rotating Display
1.
The display may be rotated up to 90° on the STS1 head by
using the 5/32" hex key (L) to loosen the fastener, rotating
the head in either direction, and tightening the fastener.
(See Figure 7)
45° left rotation
Figure 7
Display Roll, Pitch, Yaw Tension
The display roll, pitch and yaw tension can be adjusted either
using the tension adjustment knob, or the hex fastener on the
head assembly.
•
Tension Adjustment Knob
1.
Turn the tension adjustment knob counter-clockwise to
decrease tension. (See Figure 8)
2.
Adjust STS1 head and display as required.
3.
Turn adjustment knob clockwise to increase tension.
5
6
4
(L)
Figure 8
1
45° right rotation
0° rotation
2
1
•
Head Assembly Hex Fastener
4.
Loosen the head assembly hex fastener using the 5/32" hex
key (L) to decrease tension. (See Figure 8)
5.
Adjust STS1 head as required.
6.
Tighten head assembly hex fastener to increase tension.
Raising/Lowering Display
1.
Loosen, but do not remove, two Phillips head screws on
back of STS1 assembly. (See Figure 9)
2.
Adjust display and head assembly to necessary height.
3.
Tighten two Phillips head screws on back of STS1
assembly. (See Figure 9)
3
No
Extension
1
2
Maximum
Extension
Figure 9
STS1
3
7
Publicité
Table des Matières
