Cable Management - CHIEF iCLPFA1 Instructions D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 65
iCLPFA1
8
1
1
9
1
2
18
G
1/2" (12.7mm)
A
2
R
S
T
G
1/2" (12.7mm)
A
2
R
S
T
J x4
U x8
x8
INSTALL DISPLAY
TO ARM ASSEMBLY
WARNING:
Exceeding the weight capacity can
result in serious personal injury or damage to
equipment! It is the installer's responsibility to make
sure the combined weight of all components
attached to the iCLPFA1 does not exceed
125 lbs (56 kg).
1.
Align slots on upper portion of faceplate (G) with
tabs on upper portion of arm assembly (A). Lower
display into place, pivoting threaded stud on
faceplate (G) into slot on arm assembly (A).
2.
Install spacer (R), washer (S), and nut (T) onto
threaded stud. Tighten securely.

CABLE MANAGEMENT

CAUTION:
Ensure that adequate cable slack
exists for movement of display, and that cables will
not be pinched by installation of covers (J) or
screws (U).
1.
Carefully insert cables into cavities located in lower
portions of mount arms.
2.
Install each cover (J) with two screws (U).
Installation Instructions

Publicité

Table des Matières
loading

Table des Matières