Installing Set-Up Information And The Icc Profile (For Windows) - Sharp LL-T1803-H Mode D'emploi

Installing set-up information and the ICC profile
Depending on the computer or OS, it may be neces-
sary to use the computer to operate the installation
of monitor set-up information etc. If so, follow the
steps below to install the monitor set-up information.
(Depending on the type of computer or OS, com-
mand names and methods may differ. Please follow
the computer's own operation manual while reading
this.)
About the ICC profile
An ICC (International Color Consortium) profile is a
file that describes the color characteristics of the
LCD monitor. By using an application that works
together with an ICC profile, a high color resolution
can be realized.
- Windows98/2000/Me/XP all use the ICC profile.
- When installing Windows98/2000/Me/XP set-up
information (described below), the ICC profile is
also installed. If you would like to install the ICC
program only, please refer to Installing the ICC
profile on page 27.
- When using the ICC profile, please set the
[WHITE BALANCE] to [STD] .
For Windows95
Installing monitor set-up information into Windows95.
This explanation assumes that the floppy disk drive
is "A drive".
1. Place the Utility Disk (provided) into the
computer's A drive.
2. Click on the [Start] button. From [Settings],
choose [Control Panel].
3. Double click on [Display].
4. Click on [Settings], [Advanced Properties], and
[Monitor], then [Change].
5. Click on [Have disk], confirm that [Copy
manufacturer's files from:] is [A:] then click [OK].
6. Confirm that the monitor details are selected, and
click [OK].
7. Check that the monitor details are displayed, then
click [Apply].
8. Click [OK], and close the window.
(For Windows)
For Windows98
Installing monitor set-up information into Windows98,
and setting the monitor's ICC profile as a predeter-
mined value.
This explanation assumes that the floppy disk drive
is "A drive".
If the "Add new Hardware Wizard" has appeared:
1. Place the Utility Disk (provided) into the
computer's A drive.
2. Click [Next].
3. Check [Display a list of all the drivers in a
specific location, so you can select the driver you
want.], then click [Next].
4. When [Models] is displayed, click on [Have disk],
confirm that [Copy manufacturer's files from:] is
[A:], and click [OK].
5. Confirm that the monitor details are selected,
then click [Next], [Next], and [Finish]. If the "Add
New Hardware Wizard" appears, repeat the
installation commands beginning from 2 above.
If the "Add New Hardware Wizard" has not appeared:
1. Place the Utility Disk (provided) into the
computer's A drive.
2. Click on the [Start] button. From [Settings],
choose [Control Panel].
3. Double click on [Display].
4. Click on [Settings], [Advanced] and [Monitor].
5. In [Options], check [Automatically detect Plug &
Play monitors] and click on [Change].
6. Click [Next].
7. Click on [Display a list of all the drivers in a
specific location, so you can select the driver you
want.], then click [Next].
8. When [Models] is displayed, click on [Have disk],
confirm that [Copy manufacturer's files from:] is
[A:], and click [OK].
9. Confirm that the monitor details are selected,
then click [Next], [Next], and [Finish].
10. Check that the monitor details are displayed, then
click [Apply].
11. Click [OK], and close the window.
25